beautypg.com

Getting started, Key fob, Locking and unlocking the doors/liftgate – Dodge 2011 Durango - User Guide User Manual

Page 10: Power liftgate, Panic alarm, Express window feature, Emergency key

background image

KEY FOB

Locking And Unlocking The Doors/Liftgate

• Press the LOCK button once to lock all

the doors and the liftgate. Press the
UNLOCK button once to unlock the
driver’s door only and twice within five
seconds to unlock all the doors and
liftgate.

• All doors can be programmed to unlock

on the first press of the UNLOCK
button. Refer to Programmable
Features in this guide.

Power Liftgate

• Press the LIFTGATE button twice within five seconds to power open/close the

Power Liftgate. If the button is pressed while the liftgate is being power closed, the
liftgate will reverse to the full open position.

• Also, the power liftgate may be closed by pressing the Liftgate switch located on

the left rear trim, near the liftgate opening. Pressing once will close the liftgate
only. This button cannot be used to open the liftgate.

Panic Alarm

• Press the PANIC button once to turn the panic alarm on.

• Wait approximately three seconds and press the button a second time to turn the

panic alarm off.

Express Window Feature

• To remotely lower both front door windows at the same time, press and release the

UNLOCK button and then immediately press and hold the UNLOCK button until
the windows lower to the level desired or until they lower completely.

Emergency Key

• Should the battery in the vehicle or the Key Fob transmitter go dead, there is an

emergency key located in the Key Fob that can be used for locking and unlocking
the doors. To remove the emergency key, slide the button at the top of the Key Fob
sideways with your thumb and then pull the key out with your other hand.

NOTE:
• This device complies with part 15 of the FCC rules and RSS 210 of Industry Canada.

Operation is subject to the following conditions:

• This device may not cause harmful interference.
• This device must accept any interference received, including interference that

may cause undesired operation.

• Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

GETTING STARTED

8