beautypg.com

What to do in emergencies – Dodge 2011 Caliber - User Guide User Manual

Page 53

background image

• Assemble the jack and jacking tools. Connect the jack handle driver to the

extension, then to the lug wrench.

• Place the jack underneath the lift area (triangular cutout) that is closest to the flat

tire. Turn the jack screw clockwise to firmly engage the jack saddle with the lift
area of the sill flange.

• Raise the vehicle by turning the jack screw clockwise. Raise the vehicle only until

the tire just clears the surface and enough clearance is obtained to install the
spare tire.

• Remove the lug nuts, wheel cover (if equipped) and wheel.

• Position the spare wheel/tire on the vehicle and install the lug nuts with the

cone-shaped end toward the wheel. Do NOT attempt to install a center cap or
wheel cover on the compact spare. Lightly tighten the lug nuts clockwise. To avoid
the risk of forcing the vehicle off the jack, do not tighten the nuts fully until the
vehicle has been lowered.

• Lower the vehicle by turning the jack screw counterclockwise, and remove the jack

and wheel blocks.

• Finish tightening the lug nuts. Push down on the wrench while tightening for

increased leverage. Alternate nuts until each one has been tightened twice. The
correct wheel nut tightness is 100 ft lbs (135 N•m). If in doubt about the correct
tightness, have them checked with a torque wrench by your authorized dealer or at
a service station.

• Secure the tire, jack, and tools in their proper locations.

WHAT TO DO IN EMERGENCIES

51