beautypg.com

Using homelinkĥ, Reprogramming a single homelinkĥ button, Security – Dodge 2011 Caliber - Owner Manual User Manual

Page 165: Using homelink, Reprogramming a single, Homelink, Button

background image

If you unplugged the device for training, plug it back in
at this time.

Then proceed with Step 4 under “Programming
HomeLink

௡” earlier in this section.

Using HomeLink

To operate, press and release the programmed
HomeLink

௡ button. Activation will now occur for the

trained device (i.e., garage door opener, gate operator,
Security system, entry door lock, home/office lighting,
etc.,). The handheld transmitter of the device may also be
used at any time.

Reprogramming A Single HomeLink

Button

To reprogram a channel that has been previously trained,
follow these steps:

1. Turn the ignition switch to the ON/RUN position.

2. Press and hold the desired HomeLink

௡ button until

the indicator light begins to flash after 20 seconds. Do not
release the button.

3. Without releasing the button, proceed with Program-
ming HomeLink

௡ Step 2 and follow all remaining steps.

Security

It is advised to erase all channels before you sell or turn
in your vehicle.

To do this, press and hold the two outside buttons for
20 seconds until the red indicator flashes. Note that all
channels will be erased. Individual channels cannot be
erased.

The HomeLink

௡ Universal Transceiver is disabled when

the Vehicle Security Alarm is active.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

163