beautypg.com

Jacking and tire changing instructions, What to do in emergencies – Dodge 2010 Caliber - Quick Reference Guide User Manual

Page 49

background image

WARNING!

Do not attempt to change a tire on the side of the vehicle close to moving traffic. Pull
far enough off the road to avoid being hit when operating the jack or changing the
wheel.

• Set the parking brake and shift the automatic transmission into PARK, or a manual

transmission into REVERSE.

• Turn the ignition to LOCK and turn on the Hazard Warning flasher.

• Block both the front and rear of the wheel

diagonally opposite of the jacking position.
For example, if changing the right front tire,
block the left rear wheel.

NOTE: Passengers should not remain in the
vehicle when the vehicle is being jacked.

Jacking And Tire Changing Instructions

WARNING!

Carefully follow these tire changing procedures to help prevent personal injury or
damage to your vehicle: Always park on a firm, level surface as far from the edge of
the roadway as possible before raising the vehicle.

• Remove the scissors jack and lug wrench from the spare wheel as an assembly. Turn

the jack screw counterclockwise to loosen the lug wrench, and remove the wrench
from the jack assembly.

NOTE: The jack handle attaches to the side of the jack with two attachment points.
When the jack is partially expanded, the tension between the two attachment points
holds the jack handle in place.

• Loosen (but do not remove) the wheel lug nuts by turning them counterclockwise one

turn while the wheel is still on the ground.

• Assemble the jack and jacking tools. Connect the jack handle driver to the extension,

then to the lug wrench.

47

WHAT TO DO IN EMERGENCIES