NISSAN 2013 Titan - Owner's Manual - Manual (Page 140)

PROGRAMMING HOMELINK
ா
If you have any questions or are having difficulty
programming your HomeLink
ா buttons, refer to
the HomeLink ா web site at: www.homelink.com
or call 1-800-355-3515.
NOTE:
It is also recommended that a new battery
be placed in the hand-held transmitter of
the
device being programmed to
HomeLink
ா for quicker programming and
accurate transmission of the radio-
frequency.
1. Position the end of your hand-held transmit-
ter 1–3 inches (2–8 cm) away from the
HomeLink
ா surface, keeping the HomeLinkா
indicator light
᭺
1 in view.
2. Using both hands, simultaneously press and
hold the desired HomeLink
ா button and
handheld transmitter button. DO NOT re-
lease until the HomeLink
ா indicator light
᭺
1
flashes slowly and then rapidly. When the
indicator light flashes rapidly, both buttons
may be released. (The rapid flashing indi-
cates successful programming.)
NOTE:
Some devices may require you to replace
Step 2 with the cycling procedure noted in
the “Programing HomeLink
ா for Canadian
customers and gate openers” section.
3. Press and hold the programmed HomeLink ா
button and observe the indicator light.
● If
the indicator light
᭺
1 is
solid/continuous, programming is
complete and your device should acti-
vate when the HomeLink
ா button is
pressed and released.
● If the indicator light ᭺
1 blinks rapidly for
two seconds and then turns to a
solid/continuous
light, continue
with Steps 4-6 for a rolling code device.
A second person may make the following
steps easier. Use a ladder or other device.
LIC2365 LIC2366
Instruments and controls 2-59