Windshield wiper and washer switch – NISSAN 2014 Sentra - Quick Reference Guide User Manual

Page 11

To view detailed instructional videos regarding these and other features,

please go to www.nissanownersinfo.mobi.

WINDSHIELD WIPER AND WASHER SWITCH

Move the lever to the following positions to operate

the windshield wipers:

Mist (MIST) – One sweep operation of

the wipers.

Intermittent (INT) – Wipers operate

intermittently. The intermittent operation speed
can be adjusted by twisting the time control
ring

to increase or decrease wiper speed.

Low (LO) – Wipers operate at a continuous,

low speed.

High (HI) – Wipers operate at a continuous,

high speed.

Pull the lever toward you to activate the washer.

The wipers will operate several times.

WIPER BLADE REPLACEMENT PROCEDURE
The windshield wipers must be in the service position in
order to replace the wiper blades.
To move the wiper blades to the service position, follow
this procedure:
When the ignition switch is in the ON position or

within 60 seconds of placing the ignition switch
to the OFF position, push the windshield wiper
and washer lever up to the MIST position

two

times in less than 0.5 seconds. The windshield wipers will move to the service position
automatically, and the wiper blades can now be replaced.

To move the wiper blades back to the original position:
Pull the windshield wiper and washer lever up for more than 1 second or push the lever

down to operate at any wiper speed.

For more information, refer to the “Instruments and controls (section 2)” and the “Maintenance and do-it-yourself
(section 8)” of your Owner’s Manual.

MIST

Type A (if so equipped)

OFF

INT

MIST

Type B (if so equipped)

OFF

INT