NISSAN 2012 Rogue - Owner's Manual - Manual (Page 124)

If the moonroof does not operate
If the moonroof does not operate properly,
perform the following procedure to initialize the
moonroof operation system.
1. If the moonroof is open, close it fully by
repeatedly pushing the switch toward
*
2 .
2. Push and hold the switch toward
*
2 to
tilt the moonroof up.
3. Release the moonroof switch after the
moonroof moves slightly up and down.
4. Push and hold the switch toward
*
1 to
fully tilt the moonroof down.
5. Check if the moonroof switch operates
normally.
If the moonroof does not operate properly after
performing the procedure above, have your
vehicle checked by a NISSAN dealer.
CAUTION
Do not use for extended periods of time
with the engine stopped. This could
result in a discharged battery.
SIC3512
MAP LIGHTS
Push the light lens to turn the map light on or off.
The map light control switch has three positions:
ON
*
1 , DOOR
*
2 and OFF
*
3 .
The light
*
4 (if so equipped) will illuminate
when the headlight switch is turned to the
or
position.
ON position
When the switch is in the ON position
*
1 , the
map lights will illuminate.
Instruments and controls 2-53
INTERIOR LIGHTS
If the moonroof does not operate
If the moonroof does not operate properly,
perform the following procedure to initialize the
moonroof operation system.
1. If the moonroof is open, close it fully by
repeatedly pushing the switch toward
*
2 .
2. Push and hold the switch toward
*
2 to
tilt the moonroof up.
3. Release the moonroof switch after the
moonroof moves slightly up and down.
4. Push and hold the switch toward
*
1 to
fully tilt the moonroof down.
5. Check if the moonroof switch operates
normally.
If the moonroof does not operate properly after
performing the procedure above, have your
vehicle checked by a NISSAN dealer.
CAUTION
Do not use for extended periods of time
with the engine stopped. This could
result in a discharged battery.
SIC3512
MAP LIGHTS
Push the light lens to turn the map light on or off.
The map light control switch has three positions:
ON
*
1 , DOOR
*
2 and OFF
*
3 .
The light
*
4 (if so equipped) will illuminate
when the headlight switch is turned to the
or
position.
ON position
When the switch is in the ON position
*
1 , the
map lights will illuminate.
Instruments and controls 2-53
INTERIOR LIGHTS