NISSAN 2014 Murano - Owner's Manual - Manual (Page 155)

2-66 Instruments and controls
indicator light will flash slowly and then rapidly
after several seconds upon successful program-
ming. DO NOT release until the HomeLink
®
indicator light flashes slowly and then rapidly.
When the indicator light flashes rapidly, both
buttons may be released. The rapid flashing
indicates successful programming.
Proceed with “Programming HomeLink ® ” step 3
to complete.
Remember to plug the device back in when
programming is completed.
OPERATING THE HomeLink ® UNIVER-
SAL TRANSCEIVER
The HomeLink ® Universal Transceiver, after it is
programmed, can be used to activate the
programmed device. To operate, simply press
and release the appropriate programmed
HomeLink
® Universal Transceiver button. The
amber indicator light will illuminate while the
signal is being transmitted.
For convenience, the hand-held transmitter of
the device may also be used at any time.
PROGRAMMING TROUBLESHOOT-
ING
If the HomeLink ® does not quickly learn the
hand-held transmitter information:
. replace the hand-held transmitter batteries
with new batteries.
. position the hand-held transmitter with its
battery area facing away from the
HomeLink
® surface.
. press and hold both the HomeLink ® and
hand-held transmitter buttons without inter-
ruption.
. position the hand-held transmitter 1-3 in
(26-76 mm) away from the HomeLink ®
surface. Hold the transmitter in that position
for up to 15 seconds. If HomeLink
® is not
programmed within that time, try holding the
transmitter in another position - keeping the
indicator light in view at all times.
If you have any questions or are having difficulty
programming your HomeLink
® buttons, refer to
the HomeLink ® web site at: www.homelink.com
or 1-800-355-3515.
CLEARING THE PROGRAMMED IN-
FORMATION
The following procedure clears the programmed
information from both buttons. Individual buttons
cannot be cleared. However, individual buttons
can be reprogrammed, see “Reprogramming a
single HomeLink
® button” later in this section.
To clear all programming
1. Press and hold the two outer HomeLink ®
buttons until the indicator light begins to
flash in approximately 10 seconds. Do not
hold for longer than 20 seconds.
2. Release both buttons.
HomeLink ® is now in the programming mode
and can be programmed at any time beginning
with “Programming HomeLink
® ” - Step 1.
REPROGRAMMING A SINGLE
HomeLink
® BUTTON
To reprogram a HomeLink ® Universal Transcei-
ver button, complete the following.
1. Press and hold the desired HomeLink ®
button. DO NOT release the button.
2. The indicator light will begin to flash after 20
seconds. Without releasing the HomeLink ®
button, proceed with “Programming
HomeLink
® ” - Step 1.
For questions or comments, contact HomeLink ®