NISSAN 2011 Murano - Owner's Manual - Manual (Page 150)

Black plate (150,1)
[ Edit: 2011/ 7/ 12 Model: Z51-X ]
2-64 Instruments and controls
PROGRAMMING HomeLink ®
To program your HomeLink ® Transceiver to
operate a garage door, gate, or entry door
opener, home or office lighting, you need to be
at the same location as the device. Note:
Garage door openers (manufactured after
1996) have “rolling code protection”. To pro-
gram a garage door opener equipped with
“rolling code protection”; you will need to use
a ladder to get up to the garage door opener
motor to be able to access the “smart or learn”
program button.
SIC3612
1. To begin, push and hold the 2 outer
HomeLink ® buttons (to clear the memory)
until the indicator light *
A blinks (after 20
seconds). Release both buttons.
2. Position the end of the hand-held transmitter
1 to 3 in (20 to 70 mm) away from the
HomeLink
® surface.
SIC3613
3. Using both hands, simultaneously push and
hold both the HomeLink ® button you want to
program and the hand-held transmitter
button.
DO NOT release the buttons until step 4 has
been completed.
4. Hold down both buttons until the indicator
light on HomeLink ® flashes, changing from a
“slow blink” to a “rapid blink”. This could
take up to 90 seconds. When the indicator
light blinks rapidly, both buttons may be
released. The rapidly flashing light indicates
successful programming. To activate the
garage door or other programmed device,
push and hold the programmed HomeLink
®