Craftsman LAWNSWEEPER 486.242211 - Manual (Page 10)

10
STEP 13: (FIGURE 17)
IMPORTANT: Do not over bend the support rods
during the following step. Over bending will cause the
steel rods to loose supporting tension.
• Tip the hopper onto it's back to assemble the two
hopper support rods. Place the ends of each rod into
the upper and lower rear hopper tubes, bending the
rod just enough to fit into the holes in the tubes.
SNAP
FLAP
STEP 14: (FIGURE 18)
• Insert a 3/8" x 3" clevis pin (R) through the lower hole
in each upper hopper side tube. Next assemble a bag
arm tube onto each clevis pin and secure it with a
3/32" hair cotter pin (N).
• Assemble a vinyl cap (V) onto the end of each bag
arm tube.
LOWER HOLE 3/32" HAIR
COTTER PIN (N)
3/8" x 3"
CLEVIS PIN (R)
BAG ARM TUBE
VINYL CAP (V)
STEP 15: (SEE FIGURE 19 AND 20)
• Secure the rope to the top center of the hopper bag
frame.
• To assemble the hopper bag to the sweeper, slide
the ends of the bag arm tubes into the ends of the
sweeper's hitch tubes and secure with two 1/4" x
1-3/4" clevis pins (Q) and 3/32" hair cotter pins (N).
BAG ARM TUBE
1/4" x 1-3/4"
CLEVIS PIN (Q)
3/32" HAIR
COTTER PIN (N)
FIGURE 17
FIGURE 18
FIGURE 19
FIGURE 20