NISSAN 2015 GT R - Quick Reference Guide - Manual (Page 21)

To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi. 19
To verify the programing is complete, press and hold the HomeLink button and observe
the indicator light:
• A solid, continuous light indicates the programing is complete and the HomeLink
button will activate your device.
• A blinking light that turns to a solid, continuous light after 2 seconds indicates
additional steps are required to complete the programing.
An additional person may make the remaining steps easier. To complete the
programing process:
• At the receiver of the device that you are programing to the HomeLink button, press
and release the learn or smart button (the name may vary by manufacturer, but it is
usually located near where the hanging antenna wire is attached to the unit). You have
approximately 30 seconds to initiate the following step.
• Press and hold the programed HomeLink button for 2 seconds and release.
You may have to repeat the previous 2 steps up to 3 times to complete the programing
process. HomeLink should now activate your device.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual, the HomeLink website
at www.homelink.com or call 1-800-355-3515.
1655184_15b_GTR_QRGText-Insert_062414.indd 19 6/24/14 9:06 AM