NISSAN 2013 370Z Roadster - Owner's Manual - Manual (Page 119)

Black plate (117,1)
[ Edit: 2012/ 4/ 11 Model: Z34-D ]
NOTE:
It is also recommended that a new battery
be placed in the hand-held transmitter of
t h e d e v i c e b e i n g p r o g r a m m e d t o
HomeLink
® for quicker programming and
accurate transmission of the radio-fre-
quency.
1. Position the end of your hand-held transmit-
ter 1-3 in (26-76 mm) away from the
HomeLink
® surface, keeping the HomeLink ®
indicator light *
1 in view.
JVI0428X
2. Using both hands, simultaneously press and
hold the desired HomeLink ® button and
handheld transmitter button. DO NOT re-
lease until the HomeLink
® indicator light *
1
flashes slowly and then rapidly. When the
indicator light flashes rapidly, both buttons
may be released. (The rapid flashing indi-
cates successful programming.)
NOTE:
Some devices to be programmed may
require you to replace Step 2 with the
cycling procedure noted in the “Pro-
gramming HomeLink
® for Canadian
customers and gate openers” (P.2-56).
JVI0429X
3. Press and hold the programmed HomeLink ®
button and observe the indicator light.
. If the indicator light *
1 is solid/contin-
uous, programming is complete and your
device should activate when the
HomeLink
® button is pressed and re-
leased.
. If the indicator light *
1 blinks rapidly for
two seconds and then turns to a solid/
continuous light, continue with Steps 4-6
for a rolling code device. A second
person may make the following steps
easier. Use a ladder or other device. Do
not stand on your vehicle to perform the
next steps.
Instruments and controls 2-55