beautypg.com

Locks and security – FORD 2003 Crown Victoria v.3 User Manual

Page 98

background image

To replace the battery:

1. Twist a thin coin between the two
halves of the transmitter near the
key ring. DO NOT TAKE THE
FRONT PART OF THE
TRANSMITTER APART.

2. Place the positive (+) side of new
battery in the same orientation.
Refer to the diagram inside the
transmitter unit.

3. Snap the two halves back
together.

Replacement of the battery will not cause the remote transmitter to
become deprogrammed from your vehicle. The remote transmitter should
operate normally after battery replacement.

Replacing lost transmitters

Take all your vehicle’s transmitters
to your dealer if service is required.

If a remote transmitter has been lost
and you would like to remove it
from the vehicle’s memory, or you
would like to purchase additional
remote transmitters and have them
programmed to your vehicle:
• Take all your vehicle’s

transmitters to your dealer for
programming, or

• Perform the following programming procedure yourself.
Place the key in the ignition and
turn from 2 (LOCK) to 3 (OFF) and
cycle between 3 (OFF) and 4 (ON)
four times in rapid succession within
3 seconds. After doors lock/unlock,
press any control on all transmitters
(up to four). When completed, turn
the ignition to 3 (OFF).

All transmitters must be
programmed at the same time.

3

1

2

5

4

Locks and Security

98