beautypg.com

Driver controls – FORD 2003 Crown Victoria v.3 User Manual

Page 69

background image

6. The correct compass heading will be displayed when the compass is
calibrated.

Note: If the RESET button is not pressed, the compass will exit
calibration mode after three minutes of no activity and the original
calibration data will be restored.

Note: If power is interrupted during the calibration process, the compass
resets to the original calibration data from before the calibration process
started.

HomeLink

mode

Train mode

Note: Do not train the HomeLink

௡ with the vehicle parked in the garage.

To train a HomeLink

௡ button to control a specific device:

1. Select the HomeLink

௡ button to

train.

2. Press and continuously hold the
button for 20 seconds. CHANNEL X
TRANSMIT will be displayed (X will
be 1, 2, or 3) during this time.

Note: If more than one button is
pressed, priority will be given to the
lowest numbered channel.

3. After 20 seconds, the display will
read CHANNEL X TRANING to
indicate training has started.
Continue to hold the button.

Note: If the channel being trained
has not been previously trained, the
channel will immediately enter the
training mode (no 20 second delay).

4. Point the original garage door
opener/transmitter at the overhead
console. Hold down the original transmitter’s button so the overhead
console can learn the transmitter’s frequency and data stream.

Driver Controls

69