Locks and security – FORD 2004 Taurus v.2 User Manual
Page 82
3. Press and hold the 1
• 2 for two seconds to erase the customer
programmed codes.
All personal codes are now erased and only the factory set 5–digit code
will work.
Note: To exit programming mode, either wait 5 seconds after pressing 1
• 2 on the keypad, or press the 7 • 8 and 9 • 0 pads simultaneously to
lock all vehicle doors and end programming mode.
Unlocking and locking the doors using keyless entry
To unlock the driver’s door, enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate.
To unlock all doors and the liftgate (wagon), enter the factory set code
or your personal code, then press the 3
• 4 control within five seconds.
To open the trunk or unlock the liftgate (wagon), enter the factory set
code or your personal code, then press the 5
• 6 control within five seconds.
To lock all doors, press the 7
• 8 and the 9 • 0 at the same time. You
do not need to enter the keypad code first.
Autolock (if equipped)
This feature automatically locks all vehicle doors when the following
conditions are met:
• all the doors are closed,
• the engine is running,
• you shift into gear, putting the vehicle in motion, and.
• the vehicle’s speed is greater than 5 km/h (3 mph).
Relock
The autolock feature repeats when the following conditions are met:
• any door is opened then closed while the engine is running, and
• you shift into gear, putting the vehicle in motion, and
• the vehicle’s speed is greater than 5 km/h (3 mph).
To deactivate/reactivate the autolock feature using the power door
unlock control
You must complete Steps 1-7 within 30 seconds or the procedure will
have to be repeated. If the procedure needs to be repeated, you must
wait 30 seconds.
1. Turn the ignition key to the 4 (ON) position.
Locks and Security
82