FORD 2005 Freestyle v.3 - Manual (Page 73)

HOMELINK ா WIRELESS CONTROL SYSTEM (IF EQUIPPED)
The HomeLink
௡ Wireless Control System, located on the driver’s visor,
provides a convenient way to replace up to three hand-held transmitters
with a single built-in device. This feature will learn the radio frequency
codes of most transmitters to operate garage doors, entry gate operators,
security systems, entry door locks, and home or office lighting.
When programming your HomeLink
௡ Wireless Control System to
a garage door or gate, be sure that people and objects are out of
the way to prevent potential harm or damage.
Do not use the HomeLink
௡ Wireless Control System with any garage
door opener that lacks safety stop and reverse features as required by
U.S. federal safety standards (this includes any garage door opener
model manufactured before April 1, 1982). A garage door which cannot
detect an object, signaling the door to stop and reverse, does not meet
current U.S. federal safety standards. For more information, contact
HomeLink
௡ at: www.homelink.com or 1–800–355–3515.
Retain the original transmitter for use in other vehicles as well as for
future programming procedures (i.e. new HomeLink
௡ equipped vehicle
purchase). It is also suggested that upon the sale of the vehicle, the
programmed Homelink
௡ buttons be erased for security purposes, refer to
Programming in this section.
Programming
Do not program HomeLink
௡ with the vehicle parked in the garage.
Note: Your vehicle may require the ignition switch to be turned to the
ACC position for programming and/or operation of the HomeLink
௡. It is
also recommended that a new battery be placed in the hand-held
transmitter of the device being programmed to HomeLink
௡ for quicker
training and accurate transmission of the radio-frequency signal.
2005 Freestyle (219)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
73