beautypg.com

Locks and security – FORD 2005 Explorer v.2 User Manual

Page 110

background image

Power door unlock/lock procedure

You must complete steps 1-5 within
30 seconds or the procedure will
have to be repeated. If the
procedure needs to be repeated,
you must wait 30 seconds.

1. Turn the ignition to the 3 (ON)
position.

2. Press the power door unlock
control three times.

3. Turn the ignition from the 3 (ON) to the 1 (OFF/LOCK) position.

4. Press the power door unlock control three times.

5. Turn the ignition back to the 3 (ON) position. The horn will chirp.

6. Press the unlock control, then press the lock control. The horn will
chirp once if autolock was deactivated or twice (one short and one long
chirp) if autolock was activated.

7. Turn the ignition to the 1 (OFF/LOCK) position. The horn will chirp
once to confirm the procedure is complete.

Keyless entry key pad procedure

1. Turn the ignition to the 1 (OFF/LOCK) position.

2. Close all the doors, the liftgate and liftgate window.

3. Enter 5–digit entry code

4. Press and hold the 7

• 8. While holding the 7 • 8 press the 3 • 4.

5. Release the 3

• 4.

6. Release the 7

• 8.

The user should receive a horn chirp to indicate the system has been
disabled or a chirp followed by a honk to indicate the system has been
enabled.

Message center procedure

For information on activating/deactivating the autolock feature using the
vehicle’s message center (if equipped), refer to Message center
information in the Driver Controls chapter.

2005 Explorer (exp)
Owners Guide (post-2002-fmt)
USA_English
(fus)

Locks and Security

110