beautypg.com

Programming, Driver controls – FORD 2006 Crown Victoria v.2 User Manual

Page 57

background image

door to stop and reverse, does not meet current U.S. federal safety
standards. For more information, contact HomeLink

௡ at:

www.homelink.com or 1–800–355–3515. Retain the original
transmitter for use in other vehicles as well as for future programming
procedures (i.e. new HomeLink

௡ equipped vehicle purchase). It is also

suggested that upon the sale of the vehicle, the programmed HomeLink

buttons be erased for security purposes, refer to Programming in this
section.

Programming

Do not program the HomeLink

with the vehicle parked in the

garage.

Note: Some vehicles may require the ignition switch to be turned to the
second (or “ACC”) position for programming and/or operation of the
HomeLink

௡. It is also recommended that a new battery be placed in the

hand-held transmitter of the device being programmed to HomeLink

௡ for

quicker training and accurate transmission of the radio-frequency signal.

1. Press and hold the two outside
buttons. The message CLEARING
CHANNELS will appear on the
HomeLink

௡ display.

• After about 20 seconds, the

message CHANNELS CLEARED
will appear.

Do not repeat step one to program additional hand-held transmitters to
the remaining two HomeLink

௡ buttons. This will erase previously

programmed hand-held transmitter signals into HomeLink

௡.

2006 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA
(fus)

Driver Controls

57