beautypg.com

Safety belt extension assembly, Seating and safety restraints – FORD 2007 F-150 v.2 User Manual

Page 167

background image

While the design allows you to deactivate your Belt-Minder

௡, this

system is designed to improve your chances of being safely

belted and surviving an accident. We recommend you leave the
Belt-Minder

௡ system activated for yourself and others who may use the

vehicle. To reduce the risk of injury, do not deactivate/activate the
Belt-Minder

௡ feature while driving the vehicle.

1. Turn the ignition switch to the RUN (or ON) position. (DO NOT
START THE ENGINE)

2. Wait until the safety belt warning light turns off. (Approximately 1
minute)
• Step 3 must be completed within 50 seconds after the safety belt

warning light turns off.

3. For the seating position being disabled, buckle then unbuckle the
safety belt 9 times, ending in the unbuckled state. (Step 3 must be
completed within 50 seconds after the safety belt warning light turns
off.)
• After Step 3, the restraint system warning light (airbag light) will be

turned on for three seconds.

4. Within 10 seconds of the light turning on, buckle then unbuckle the
safety belt.
• This will disable the Belt-Minder௡ feature for that seating position if it

is currently enabled. As confirmation, the restraint system warning
light will flash 4 times per second for 3 seconds.

• This will enable the Belt-Minder௡ feature for that seating position if it

is currently disabled. As confirmation, the restraint system warning
light will flash 4 times per second for 3 seconds, followed by 3
seconds with the light off, then followed by the restraint system
warning light flashing 4 times per second for 3 seconds again.

Safety belt extension assembly

If the safety belt is too short when fully extended, there is a 8 inch
(20 cm) safety belt extension assembly that can be added (part number
611C22). This assembly can be obtained from an authorized dealer.

Use only extensions manufactured by the same supplier as the safety
belt. Manufacturer identification is located at the end of the webbing on
the label. Also, use the safety belt extension only if the safety belt is too
short for you when fully extended.

2007 F-150 (f12)
Owners Guide (post-2002-fmt)
USA
(fus)

Seating and Safety Restraints

167