beautypg.com

Gate operator & canadian programming, Driver controls – FORD 2007 F-150 v.2 User Manual

Page 113

background image

Note: There are 30 seconds in which to initiate Step 7.

7. Return to the vehicle and firmly press, hold for two seconds and
release
the programmed HomeLink

௡ button. Repeat the

press/hold/release sequence again, and, depending on the brand of the
garage door opener (or other rolling code equipped device), repeat this
sequence a third time to complete the programming.

HomeLink

௡ should now activate your rolling code equipped device. To

program additional HomeLink

௡ buttons begin with Step 2 in the

“Programming” section. For questions or comments, please contact
HomeLink

௡ at www.homelink.com or 1–800–355–3515.

Gate Operator & Canadian Programming

During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink

௡ to accept the signal

from the hand-held transmitter.

After completing Steps 1 and 2
outlined in the “Programming”
section, replace Step 3 with the following:

Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
• Continue to press and hold the HomeLink௡ button (note Step 3 in the

“Programming” section) while you press and release — every two
seconds
(“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink

௡. The indicator light will

flash slowly and then rapidly after HomeLink

௡ accepts the radio

frequency signal.

• Proceed with Step 4 in the “Programming” section.

2007 F-150 (f12)
Owners Guide (post-2002-fmt)
USA
(fus)

Driver Controls

113