beautypg.com

Positive retention floor mat, Driver controls – FORD 2007 Crown Victoria v.2 User Manual

Page 79

background image

LOW WASHER FLUID. Indicates the washer fluid reservoir is less than
one quarter full. Check the washer fluid level. Refer to Windshield
washer fluid
in the Maintenance and Specifications chapter.

CHANGE ENGINE OIL. Displayed when the engine oil life remaining is
5 percent or less. When oil life left is between 5% and 0%, the CHANGE
OIL SOON message will be displayed. When oil life left reaches 0%, the
OIL CHANGE REQUIRED message will be displayed.

An oil change is required whenever indicated by the message center and
according to the recommended maintenance schedule. USE ONLY
RECOMMENDED ENGINE OILS.

To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:

1. Press and hold the RESET
control for 2 seconds and release.
Oil life is set to 100% and “OIL LIFE
XXX% HOLD RESET IF NEW OIL”
is displayed.

2. Press and hold the RESET
control for 3 seconds and release.
Oil life is set to 100% and “OIL LIFE
START VALUE SET TO XXX%” is
displayed.

POSITIVE RETENTION FLOOR MAT

Do not install additional floor mats on top of the factory installed
floor mats as they may interfere with the accelerator or the

brake pedals.

2007 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA
(fus)

Driver Controls

79