Driver controls, Multi-function lever, Windshield wiper/washer control – FORD 2008 Mustang v.1 User Manual
Page 57
MULTI-FUNCTION LEVER
Windshield wiper: For intermittent
operation, move control up one
position.
Adjust the rotary control to the
desired speed setting.
For normal or low speed wiper
operation, move control up two
positions from OFF.
For high speed wiper operation,
move control up three positions
from OFF.
Windshield washer: Pull the end
of the stalk towards you:
• briefly: causes a single swipe of
the wipers without washer fluid.
• a quick pull and hold: the wipers
will swipe three times with
washer fluid.
• a long pull and hold: the wipers and washer fluid will be activated for
up to ten seconds.
Note: Do not operate the washer when the washer reservoir is empty.
This may cause the washer pump to overheat. Check the washer fluid
level frequently. Do not operate the wipers when the windshield is dry.
This may scratch the glass, damage the wiper blades and cause the wiper
motor to burn out. Before operating the wiper on a dry windshield,
always use the windshield washer. In freezing weather, be sure the wiper
blades are not frozen to the windshield before operating the wipers.
2008 05+ Mustang (197)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
57