beautypg.com

Manual transmission operation (if equipped), Using the clutch, Driving – FORD 2008 Focus v.1 User Manual

Page 163

background image

If necessary, try turning the Traction Control™ system off. This will
allow the wheels to spin, which may help to free your stuck vehicle. For
more information, refer to Traction Control™ in this chapter.

Do not rock the vehicle if the engine is not at normal operating
temperature or damage to the transmission may occur.

Do not rock the vehicle for more than a minute or damage to the
transmission and tires may occur, or the engine may overheat.

MANUAL TRANSMISSION OPERATION (IF EQUIPPED)

Using the clutch

The manual transaxle has a starter interlock that prevents cranking the
engine unless the clutch pedal is fully depressed.

To start the vehicle:

1. Make sure the parking brake is fully set.

2. Press the clutch pedal to the floor, then put the gearshift lever in the
neutral position.

3. Start the engine.

4. Press the brake pedal and move the gearshift lever to the desired
gear; 1 (First) or R (Reverse).

5. Release the parking brake, then slowly release the clutch pedal while
slowly pressing on the accelerator.

During each shift, the clutch pedal must be fully depressed to the floor.
Make sure the floor mat is properly positioned so it doesn’t interfere with
the full extension of the clutch pedal.

Failure to fully depress the clutch pedal to the floor may cause
increased shift efforts, prematurely wear transaxle components
or damage the transaxle.

Do not drive with your foot resting on the clutch pedal or use the
clutch pedal to hold your vehicle at a standstill while waiting on a
hill. These actions will reduce the life of the clutch.

1

3

5

2

4

R

2008 Focus (foc)
Owners Guide (post-2002-fmt)
USA
(fus)

Driving

163

This manual is related to the following products: