beautypg.com

Erasing homelink buttons, Reprogramming a single homelink button, Message center – FORD 2009 Taurus X v.2 User Manual

Page 117: Selectable features, Reset, Driver controls

background image

Erasing HomeLink

buttons

To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer

HomeLink

௡ buttons until the

indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.

HomeLink

௡ is now in the train (or learning) mode and can be

programmed at any time beginning with Step 1 in the Programming
section.

Reprogramming a single HomeLink

button

To program a device to HomeLink

௡ using a HomeLink௡ button previously

trained, follow these steps:
1. Press and hold the desired HomeLink

௡ button. Do NOT release the

button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink

௡ button, follow Step 1 in the Programming

section.
For questions or comments, contact HomeLink

௡ at www.homelink.com

or 1–800–355–3515.

MESSAGE CENTER

With the ignition on, the message
center, located on your instrument
cluster, displays important vehicle
information through a constant
monitor of vehicle systems.
You
may select display features on the
message center for a display of status. The system will also notify you of
potential vehicle problems with a display of system warnings followed by
a long indicator chime.

Selectable features

Reset
Press this control to select and reset functions shown in the INFO menu
and SETUP menu.

2009 Taurus X (219)
Owners Guide, 2nd Printing
USA
(fus)

Driver Controls

117