beautypg.com

Gate operator & canadian programming, Operating the homelink wireless control system, Driver controls – FORD 2009 Taurus X v.2 User Manual

Page 116

background image

Gate Operator & Canadian Programming

During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink

௡ to accept the signal

from the hand-held transmitter.

After completing Step 1 outlined in
the Programming section, replace
Step 2 with the following:

Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
• Continue to press and hold the HomeLink௡ button (note Step 2 in the

Programming section) while you press and release —

every two

seconds (“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink

௡. The indicator light will

flash slowly and then rapidly after HomeLink

௡ accepts the radio

frequency signal.

• Proceed with Step 3 in the Programming section.

Operating the HomeLink

Wireless Control System

To operate, simply press and release
the appropriate HomeLink

௡ button.

Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the event that there are still
programming difficulties, contact HomeLink

௡ at www.homelink.com or

1–800–355–3515.

2009 Taurus X (219)
Owners Guide, 2nd Printing
USA
(fus)

Driver Controls

116