Casio WK6500E1A User Manual
Page 117
Reference
E-115
Notes keep sounding, without stopping.
• Turn power off and then back on to initialize all Digital Keyboard settings
(page E-13).
• Replace the batteries with new ones or switch over to AC adaptor power
(page E-9).
Some notes are cut off while they are
playing.
Notes are cut off whenever the number of notes being sounded exceeds the
maximum polyphony value of 48 (24 for some tones). This does not indicate
malfunction. See the separate “Appendix”.
The volume or tone setting I configured has
changed.
• Adjust the main volume setting (page E-13).
• Turn power off and then back on to initialize all Digital Keyboard settings
(page E-13).
• Replace the batteries with new ones or switch over to AC adaptor power
(page E-9).
Output volume does not change even though
I change my keyboard pressure.
• Change the Touch Response setting (page E-97).
• Turn power off and then back on to initialize all Digital Keyboard settings
(page E-13).
In certain keyboard ranges, the volume and
tone quality sound are slightly different from
those in other keyboard ranges.
This is due to system limitations. It does not indicate malfunction.
With some tones, octaves do not change at
the far ends of the keyboard.
This is due to system limitations. It does not indicate malfunction.
The pitch of the notes does not match other
accompanying instruments or sounds
strange when played along with other
instruments.
• When the B indicator is displayed, it means that the transpose setting
(page E-18) has been used to change the pitch of the keyboard. Return the
transpose setting to 00.
• When the C indicator is displayed, it means that the scale setting (page
E-21) has been used to change the Digital Keyboard’s initial default setting.
Use the procedure under “To select a preset scale” (page E-21) to change to
the “Equal” preset scale. If the C indicator remains on the display after
you select “Equal”, use the dial or the R-14 (–, +) buttons to change to
another preset scale other than “Equal” and then select “Equal” again.
• Turn power off and then back on to initialize all Digital Keyboard settings
(page E-13).
The reverb of notes seems to change
suddenly.
• Check and adjust the reverb setting (page E-34).
• Turn power off and then back on to initialize all Digital Keyboard settings
(page E-13).
Operation
Tone, rhythm, and other settings revert to
their initial defaults whenever you turn on the
Digital Keyboard.
The Digital Keyboard may be configured to restore default settings (factory
default settings or settings registered by you) when power is turned on. If you
want the Digital Keyboard to remember its last setup and restore it the next time
it is turned on, select “on” for the Auto Resume setting (page E-100).
Computer Connection
I can’t exchange data between the Digital
Keyboard and a computer.
• Check to make sure that the USB cable is connected to the Digital Keyboard
and computer, and that the device is selected correctly with your computer’s
music software settings (page E-112).
• Turn off the Digital Keyboard and then exit the music software on your
computer. Next, turn the Digital Keyboard back on and then restart the music
software on your computer.
Symptom
Action
CTK6000_e.book 115 ページ ２０１０年７月１２日 月曜日 午後１２時５０分