beautypg.com

Programming a personal entry code, Erasing personal code, Locks and security – FORD 2009 F-150 v.2 User Manual

Page 139

background image

The anti-scan feature will be turned off after:
• one minute, when the anti-scan feature times out.
• one minute of keypad inactivity.
• the

control is pressed on the remote entry transmitter.

• the ignition is turned from the off position to the on position, or from

the on position to the off position.

Programming a personal entry code

To create your own personal entry code:

1. Enter the factory set code (keypad will illuminate when pressed).

2. Within five seconds press the 1

• 2 on the keypad.

3. Enter your personal 5-digit code. Each number must be entered
within five seconds of each other.

4. After the code is entered, the locks will cycle, confirming that the new
code has been set.

Tips:
• Do not set a code that uses five of the same number.
• Do not use five numbers in sequential order.
• The factory set code will work even if you have set your own personal

code.

• If you set a second personal code it will erase your first personal code.

Erasing personal code

1. Enter the factory set 5–digit code.

2. Press and release 1

• 2 then,

3. Press and hold the 1

• 2 for two seconds. This must be done within

five seconds of completing Step 1.

Your personal code is now erased and only the factory set 5–digit code
will work.

2009 F-150 (f12)
Owners Guide, 2nd Printing
USA
(fus)

Locks and Security

139