FORD 2009 Explorer v.3 - Manual (Page 129)

2. Locate the reset button on the compass sensor mounted on the base
of mirror.
3. To calibrate, press and hold the reset button on the compass module
for approximately eight seconds until CIRCLE SLOW TO CALIBRATE
appears on the display; then release the reset button.
4. Slowly drive the vehicle in a circle (less than 3 mph [5 km/h]) until
the CIRCLE SLOW TO CALIBRATE display changes to CALIBRATION
COMPLETED. It will take up to five circles to complete calibration.
5. The compass is now calibrated.
Compass zone adjustment using the SELECT/RESET stem located
on the cluster (if equipped)
1. Determine which magnetic zone
you are in for your geographic
location by referring to the zone
map.
2. Turn the ignition on. Press the
SELECT/RESET stem to scroll
through the message center until it
displays SETUP MENU HOLD
RESET.
3. Press and hold the
SELECT/RESET stem to enter the
setup menu option. Press and release the SELECT/RESET stem to scroll
through the message center until it displays RESET FOR ZONE
SETTING.
4. Press and hold the SELECT/RESET stem for approximately four
seconds until the message center displays: ZONE RESET
CHANGE.
5. Hold and release the SELECT/RESET stem to change the zone. (A
quick press will exit out from the zone setting option.)
Compass calibration adjustment using the SELECT/RESET stem
located on the cluster (if equipped)
NOTE: For optimum calibration, drive to an open, level location away
from large metallic objects or structures. Switch off all non-essential
electrical accessories (heated rear window, heater, A/C, map lamps,
wiper, etc.) and make sure all the doors are closed.
1. Start the vehicle. Press the SELECT/RESET stem to scroll through the
message center until it displays SETUP MENU HOLD RESET.
1 2 3
4
5
6 7 8 9 1011
12
13
14
15
Driver Controls
129
REVIEW COPY ——
2009 Explorer (exp), Owners Guide (own2002), 3rd Printing, Market: USA
(fus)