beautypg.com

Locks and security – FORD 2010 F-550 v.2 User Manual

Page 151

background image

• using a keypad procedure (if equipped)
Note: The autounlock feature can be activated/deactivated
independently of the autolock feature.

Power door lock switch autounlock enable/disable procedure

Before starting, ensure the ignition is in the off position and all vehicle
doors are closed. You must complete Steps 1–5 within 30 seconds or the
procedure will have to be repeated. If the procedure needs to be
repeated, wait a minimum of 30 seconds before beginning again.

1. Place the key in the ignition and
turn the ignition to the on position.

2. Press the power door unlock
control on the door panel three
times.

3. Turn the ignition from the on
position to the off position.

4. Press the power door unlock control on the door panel three times.

5. Turn the ignition back to the on position. The horn will chirp one time
to confirm programming mode has been entered and is active.

6. To enable/disable the autounlock feature, press the lock control, then
press the unlock control. The horn will chirp once if autounlock was
deactivated or twice (one short and one long chirp) if autounlock was
activated.

7. Turn the ignition to the off position. The horn will chirp once to
confirm the procedure is complete.

Keyless entry keypad autounlock enable/disable procedure

1. Turn the ignition to the off
position.

2. Close all the doors.

3. Enter factory–set 5–digit entry
code.

4. Press and hold the 3

• 4. While holding the 3 • 4, press and release

the 7

• 8. While still holding the 3 • 4, press and release the 7 • 8 a

second time.

5. Release the 3

• 4.

The user should receive a horn chirp to indicate the system has been
disabled or a chirp followed by a honk to indicate the system has been
enabled.

Locks and Security

151

2010 F-250/350/450/550 (f23)
Owners Guide, 2nd Printing
USA
(fus)

This manual is related to the following products: