FORD 2010 F-150 v.3 - Manual (Page 283)

If you switch off the AdvanceTrac
௡ with RSC௡ system, the stability
control light will illuminate steadily. Pressing the traction control off
button again will turn off the stability control light.
In R (Reverse), ABS and the engine traction control and brake traction
control features will continue to function; however, ESC and RSC
௡ are
disabled.
AdvanceTrac
௡ with RSC௡ Features
Button functions
Stability
control
light
RSC
௡
ESC TCS
Default at start-up
Illuminated
during
bulb check
Enabled Enabled Enabled
Button pressed
momentarily Illuminated
solid
Enabled Enabled 1 Disabled
Button pressed and
held for more than
5 seconds at vehicle
speed under 35 mph
(56 km/h)
Flashes
then
illuminated
solid 2
Disabled Disabled Disabled
Vehicle speed exceeds
35 mph (56 km/h) after
button is pressed and
held for more than
5 seconds
Illuminated
solid
Enabled Enabled 1 Disabled
Button pressed again
after deactivation Not
illuminated
Enabled Enabled Enabled
Transfer case switched
to 4WD Low Locked
3,4
Illuminated Disabled Disabled Disabled
1 TCS is enabled but with higher entry thresholds compared to full
system.
2 Lamp light starts blinking for 3 seconds after entering press and hold
state.
3 Control switch is not pressed. Stability control light turned on when
4WD low locked transfer case mode selected.
4 If the button is pressed in 2WD or 4WD high, any change in the transfer
case mode will return the AdvanceTrac
௡ to fully enabled.
Driving
283
2010 F-150 (f12)
Owners Guide, 3rd Printing
USA (fus)