beautypg.com

Switching from two step to one step door unlocking, Locking the doors, Opening the liftgate glass (if equipped) – FORD 2010 Escape Hybrid v.1 User Manual

Page 102: Car finder, Sounding a panic alarm, Locks and security

background image

Switching from two step to one step door unlocking

Unlocking can be switched between two step and one step door
unlocking by pressing and holding both

and

buttons

simultaneously on the remote entry transmitter for approximately
4 seconds. The turn signal will flash twice to indicate that the vehicle has
switched to one step unlocking. Repeat the procedure to switch back to
two step unlocking.

Locking the doors

1. Press

and release to lock all the doors. Assuming all vehicle doors

and the liftgate are properly closed and the parking lamps will flash
once.

2. Press

and release again within three seconds to confirm that all

the doors and liftgate are closed and locked. Note: The doors will lock
again and the horn will chirp once.

If any of the doors or the hood are not properly closed, the horn will
chirp twice and parking lamps will not flash when the

control is

pressed.

Opening the liftgate glass (if equipped)

Press

twice within three seconds to open the liftgate glass.

Car finder

Press

twice within three seconds. The horn will chirp and the turn

lamps will flash. It is recommended that this method be used to locate
your vehicle, rather than using the panic alarm.

Sounding a panic alarm

Press

to activate the alarm. To deactivate the feature, press the

control again, turn the ignition to the on or start position, or wait for the
alarm to time out in approximately three minutes.

Note: The panic alarm will only operate when the ignition is in the off
position.

Locks and Security

102

2010 Escape Hybrid (ehv)
Owners Guide, 1st Printing
USA
(fus)