beautypg.com

Fcc and rss-210 industry canada compliance, Positive retention floor mat, Driver controls – FORD 2011 Mustang v.1 User Manual

Page 87

background image

To erase programming on the Car2U

௡ system (individual buttons cannot

be erased), use the following procedure:

1. Firmly press the two outside
Car2U

௡ system buttons

simultaneously for approximately
20 seconds until the indicator lights
begin to blink rapidly. The indicator
lights are located directly above the
buttons.

2. Once the indicator lights begin to
blink, release your fingers from the
buttons. The codes for all buttons
are erased.

If you sell your vehicle equipped with the Car2U

௡ system, it is

recommended that you erase the programming for security reasons.

FCC and RSS-210 Industry Canada Compliance

The Car2U

௡ system complies with Part 15 of the FCC rules and with

RSS-210 of Industry Canada. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received including interference
that may cause undesired operation.

Changes and modifications to the Car2U

௡ system transmitter by other

than an authorized service facility could void authorization to use the
equipment.

POSITIVE RETENTION FLOOR MAT

WARNING: Do not install additional floor mats on top of the
factory installed floor mats as they may interfere with the

accelerator or the brake pedals.

Driver Controls

87

2011 05+ Mustang (197)
Owners Guide, 1st Printing
USA
(fus)