beautypg.com

Erasing the function button codes, Reprogramming a single button, Positive retention floor mat – FORD 2012 Focus Electric User Manual

Page 152: 152 driver controls

background image

Erasing the Function Button Codes

Note: You can not erase individual
buttons.

1. Press and hold the outer two
function buttons simultaneously for
approximately 20 seconds until the
indicator lights above the buttons
flash rapidly.

2. When the indicator lights flash,
release the buttons. The codes for
all buttons are erased.

Reprogramming a single button

To program a device to a previously trained button, follow these steps:

1. Press and hold the desired button. Do NOT release the button.

2. The indicator light will begin to flash after 20 seconds. Without
releasing the button, follow Step 1 in the Programming section.

For questions or comments, contact HomeLink

௡ at www.homelink.com or

1-800-355-3515.

Positive Retention Floor Mat

WARNING: Always use floor mats that are designed to fit the
foot well of your vehicle. Only use floor mats that leave the pedal

area unobstructed. Only use floor mats that are firmly secured to
retention posts so that they cannot slip out of position and interfere
with the pedals or impair safe operation of your vehicle in other ways.
• Pedals that cannot move freely can cause loss of vehicle control and

increase the risk of serious personal injury.

152

Driver Controls

2012 Focus Electric Vehicle (fob)
Owners Guide gf, 1st Printing
USA
(fus)