FORD 2012 F-150 Raptor v.2 - Manual (Page 119)

For questions or comments, contact HomeLink
௡ at www.homelink.com or
1-800-355-3515.
Programming HomeLink
ா to a Genie Intellicodeா 2 garage door
opener
Note: The Genie Intellicode 2
௡ transmitter must already be programmed
to operate with the garage door opener.
Programing the transmitters
To program HomeLink
௡ to the transmitter you must first put the
transmitter into programming mode. To do this
A. Red LED
B. Green LED
1. Press and hold one of the buttons on the transmitter for 10 seconds.
The LED light will change from green to green and red.
2. Press the same button twice to confirm the change to Programming
mode. If done properly the LED light will appear red.
3. Hold the transmitter within 1–3 inches (2–8 cm) of the HomeLink
௡
button.
4. Press and hold the both the programmed Genie button and the
HomeLink
௡ button you want to program. The HomeLink௡ LED will flash
rapidly when the programming is successful.
Note: the Genie transmitter will transmit for up to 30 seconds. If
HomeLink
௡ does not program within 30 seconds the Genie transmitter
will need to be pressed again. If the Genie transmitter LED displays
green and red, release the button until the LED turns off before pressing
the button again.
B A
Driver Controls
119
2012 F-150 (f12)
Owners Guide, 2nd Printing
USA (fus)