Locks and security – FORD 2012 Edge User Manual
Page 116
• Low fuel warnings are displayed in the message center followed by a
chime when the distance to empty value reaches 75 miles (120 km).
• If equipped, any of the following: parking aid, blind spot information
system (BLIS
) with cross traffic alert and forward collision warning
systems cannot be turned off.
Optional settings – these settings can be changed
• Vehicle speed is limited to 80 mph (130 km/h). Visual warnings are
displayed followed by a chime when the vehicle speed has reached
80 mph (130 km/h).
• Visual warnings are displayed followed by a chime when a preselected
vehicle speed of 45, 55 or 65 mph (75, 90, or 105 km/h) is exceeded.
• The maximum volume of the audio system is limited to 45%. MYKEY
VOLUME LIMITED will be displayed in the audio system display when
attempting to exceed the limited volume.
• The AdvanceTrac system cannot be turned off. When this optional
setting is on, the MyKey
user will not be able to deactivate the
system. Note: It may be beneficial to deactivate the AdvanceTrac
system if the vehicle is stuck in snow, mud, or sand.
Create a MyKey
To program MyKey
on one of the keys programmed to the vehicle,
insert the key that you want to make a MyKey
into the ignition. For
vehicles equipped with push button start, put the intelligent access key
in the backup slot with brand logo facing up; refer to Starting in the
Driving chapter for the location of the backup slot. Turn the ignition on.
Use the message center buttons to do the following:
1. Get into main menu, select SETTINGS then MYKEY by pressing OK
button or the right arrow button.
2. Press OK to select CREATE MYKEY.
3. Hold the OK button as prompted until you see a message that the key
is restricted.
MyKey
is successfully programmed. Make sure you label it so you can
distinguish it from the admin keys. Note: To program the optional
settings go to Step 2 in the Programming MyKey
Optional Settings
section. If your vehicle is equipped with remote start, see the Using
MyKey
with remote start systems section.
Note: All MyKeys
can be cleared within the same key cycle that it was
created, otherwise an admin key is required to clear the MyKey
programming. To clear all MyKeys
go to Step 2 in the Clear MyKey
section.
Locks and Security
116
2012 Edge (edg)
Owners Guide, 1st Printing
USA (fus)