FORD 2013 F-550 v.1 - Manual (Page 107)

To reset the oil monitoring system to 100% after each oil change,
perform the following:
1. Press and release the SETUP button to display OIL LIFE XXX% HOLD
RESET = NEW.
2. Press and hold the RESET button for two seconds and release to reset
the oil life to 100%.
Note: To change oil life 100% value (if equipped with this feature) to
another value, proceed to Step 3.
3. Once OIL LIFE SET TO XXX% is displayed, release and press the
RESET button to change the Oil Life Start Value. Each release and press
will reduce the value by 10%.
• UNITS: Displays the current units in English or Metric.
• AUTOLAMP (SEC): This feature keeps your headlights on for up to
three minutes after the ignition is switched off.
• AUTOLOCK: This feature automatically locks all vehicle doors when
the vehicle is shifted into any gear, putting the vehicle in motion.
• AUTOUNLOCK: This feature automatically unlocks all vehicle doors
when the driver’s door is opened within 10 minutes of the ignition
being turned off.
• COURTESY WIPE: This feature allows for an extra swipe of the wipers
after a wipe/wash cycle.
• CREATE MYKEY / MYKEY SETUP / CLEAR MYKEY: For more
information refer to MyKey® in the Locks and Security chapter.
• RESET FOR ZONE SETTING (if equipped): This feature changes the
compass zone setting.
Most geographic areas (zones) have a magnetic north compass point
that varies slightly from the northerly direction on maps. This variation
is four degrees between adjacent zones and will become noticeable as
the vehicle crosses multiple zones. A correct zone setting will
eliminate this error.
Refer to Compass zone/calibration adjustment.
• ZONE XX RESET = CHANGE (if equipped): The compass heading is
displayed as one of N, NE, E, SE, S, SW, W and NW in the message
center display.
Refer to Compass zone/calibration adjustment.
106 Information Displays
2013 F-250/350/450/550 (f23)
Owners Guide gf, 1st Printing
USA (fus)