FORD 2013 F-150 v.2 - Manual (Page 80)

Programming Memory to a Personal Entry Code
To program a personal entry code to recall memory settings, repeat
Steps 1–4 above.
• Pressing 1•2 on the keypad in Step 4 will program the code to driver
memory setting 1.
• Pressing 3•4 in Step 4 will program the code to driver memory
setting 2.
Note: Pressing 5
•6, 7•8, or 9•0 keypad numbers in Step 4 will not
program the code to recall a driver memory setting.
Note: The factory-set code cannot be associated with a memory setting.
You may also program a personal entry code through the MyFord Touch /
MyLincoln Touch system. Refer to the MyFord Touch / MyLincoln
Touch chapter.
Erasing a Personal Code
1. Enter the factory-set 5-digit code.
2. Press and release the 1
•2 on the keypad within five seconds.
3. Press and hold the 1
•2 for two seconds. This must be done within
five seconds of completing Step 2.
All personal codes are now erased and only the factory-set 5-digit code
will work.
Anti-Scan Feature
The keypad will go into an anti-scan mode if you enter the wrong code
seven times (35 consecutive button presses). This mode disables the
keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
• one minute of keypad inactivity
• pressing the unlock button on the remote control
• the ignition is turned on.
Locks 79
2013 F-150 (f12)
Owners Guide gf, 2nd Printing, October 2012
USA (fus)