Load carrying – FORD 2014 F-550 v.3 User Manual
Page 188
Opening the Step
Note: Make sure to close and fully latch the
step before moving your vehicle. Never drive
with the step or grab handle open.
1.
Lower the tailgate.
2. Pull the yellow lever on the grab handle
to the unlock position.
E163093
3. Raise the handle upright until you feel
it latch and see the lever in the lock
position. You only need to use the lever
when releasing the grab handle.
E163094
4. Rotate the center molding to unlatch
the step. Pull it toward you to extend
it.
5. Open the step panel to widen the step.
Note: Do not tow with the step or grab
handle.
Replace the slip resistance tape or grab
handle molding if it appears worn or
damaged.
Closing the Step
1.
Close the step panel then lift and fully
close the step into the tailgate.
2. Move the yellow lever on the grab
handle to the unlock position and lower
the handle.
Bed Extender
(If Equipped)
Note: Do not use the bed extender when
driving off road.
Note: Make sure to engage the locking pins
and knobs fully before driving your vehicle.
Note: Make sure to secure all cargo.
Note: Do not exceed 150 pounds (68
kilograms) on the tailgate when your vehicle
is moving.
Note: Do not keep the bed extender in the
tailgate mode when you are not using it for
restraining cargo. Always keep the bed
extender in the grocery mode or the stowed
position with the tailgate closed.
Tailgate Mode
E163095
1.
Pull the locking pin toward the center
of your vehicle.
185
Super Duty (TFA)
Load Carrying