BMW Z4 Roadster 2.5i 2004 User Manual
Page 91
89
1.
Open the caps with a suitable object,
e.g. a coin or screwdriver
2.
Fold up the protective cover in the
wheel well.
Headlamp cover
1.
Pull the wire clamp out straight
2.
Pull the wire clamp past the catches,
see arrows, and fold it down
3.
Flip the headlamp cover open and
remove.
Reinstall the headlamp cover care-
fully. If it is not on tight, the headlamp
installation could be damaged.
<
Reinstall the headlamp cover in reverse
order.
Low beams and high beams
Left side of engine compartment:
1
Low beams
2
High beams
H7 bulb, 55 watts
The H7 bulb is pressurized. There-
fore, wear safety glasses and protec-
tive gloves. Failure to comply with these
precautions could result in physical injury if
the bulb is damaged.
<
1.
Turn the bulb holder to the left and pull
out
2.
Remove and replace the bulb
3.
Install in the reverse order.
When cleaning the headlamps,
please observe the instructions in the
Caring for your vehicle brochure.
<
Xenon lamps*
The service life of these bulbs is very long
and the probability of a failure is very low,
provided that they are not switched on and
off an unusual number of times. If one of
these bulbs should nevertheless fail, it is
possible to continue driving with great cau-
tion using the fog lamps, provided traffic
laws in your area do not prohibit this.
Because of the extremely high volt-
ages involved, any work on the xenon
lighting system, including bulb-changing,
should be carried out by technically quali-
fied personnel only. Otherwise, there is a
risk of fatal injury.
<
Online Version for Part No. 01 41 0 157 498 - © 10/03 BMW AG