beautypg.com

Replacing components, Onboard tool kit, Windshield wiper blades – BMW Z4 Coupe 2006 User Manual

Page 95: Lamps and bulbs

background image

Re

fe

re

n

c

e

A

t a

g

lanc

e

Co

n

tr

o

ls

D

riv

in

g tip

s

M

o

b

ilit

y

93

Replacing components

Onboard tool kit

The onboard tool kit is stored in a tool pouch. It
is located in the cargo bay beneath the floor
panel.

Windshield wiper blades

1.

Fold up the wiper arm.

2.

Place the wiper blade in a position at right
angles to the wiper arm.

3.

Press the locking spring.

4.

Fold in the wiper blade and unhook it in the
direction of the windshield.

5.

Pull the wiper blade past the wiper arm
toward the top.

6.

Insert the new wiper blade and press it on
until it audibly engages.

Lamps and bulbs

Lamps and bulbs make an essential contribu-
tion to vehicle safety. They should, therefore,

be handled carefully. BMW recommends hav-
ing your BMW Center perform any work that
you do not feel competent to perform yourself
or that is not described here.

Do not touch the glass portion of a new
bulb with your bare hands since even

small amounts of impurities burn into the sur-
face and reduce the service life of the bulb. Use
a clean cloth, paper napkin or a similar material,
or hold the bulb by its metallic base.

<

A replacement bulb set is available from your
BMW Center.

When working on electrical systems,
always begin by switching off the corre-

sponding consumers, otherwise short-circuits
could result. To avoid possible injury or equip-
ment damage when replacing bulbs, be sure to
observe any instructions provided by the bulb
manufacturer.

<

For care and maintenance of the headlamps,
please follow the instructions in the separate
Caring for your vehicle brochure.

If the routine for changing a particular
bulb is not described here, please contact

your BMW Center or a workshop that works
according to BMW repair procedures with cor-
respondingly trained personnel.

<

Light-emitting diodes LEDs

Control elements, display units and other inte-
rior equipment in your vehicle use a light-emit-
ting diode behind a cover as a light source.
These light-emitting diodes, which operate
using a concept similar to that applied in con-
ventional lasers, are officially designated as
Class 1 light-emitting diodes.

Do not remove the covers, and do not
look directly at the unfiltered light for sev-

eral hours. Otherwise, your eyes could suffer
irritation of the retina.

<

Online Edition for Part-No. 01 41 0 012 083 - © 04/06 BMW AG

This manual is related to the following products: