BMW X3 3.0si 2008 - Manual (Page 34)

Adju
stmen
ts
32
Requesting a stored setting
Do not request a position from the mem-
ory while the vehicle is moving; otherwise,
there is a risk of accident from unexpected seat
movement.
<
Convenience mode
1. Open the driver's door after unlocking or
turn the ignition key to position 1.
2. Briefly press the desired memory button 1 ,
2 or 3 .
The adjustment procedure is canceled when
you press one of the seat adjustment buttons or
use one of the memory buttons.
Safety feature
1. Close the driver's door and turn the ignition
key to position 0 or 2.
2. Press the desired memory button 1 , 2 or 3
and maintain pressure until the adjustment
process has been completed.
If the button has been pressed inadvert-
ently:
Press the button again, the LED goes out.
You can have your vehicle programmed
to automatically recall your own individual
stored adjustment settings for the seat and
exterior mirror position whenever you use your
personal remote control to unlock the vehicle.
<
If you make use of this setting, be sure
that the footwell behind the driver's seat
is unobstructed before unlocking the vehicle.
If you fail to do so, any persons, animals or
objects behind the seat could be injured or
damaged by a rearward movement of the
seat.
<
Safety belts
To ensure that the safety systems con-
tinue to provide optimum protection,
please follow the instructions on page 27 . <
Make sure the safety belts are worn in all occu-
pied seats every time you drive. Although air-
bags enhance safety by providing added pro-
tection, they are not a substitute for safety
belts.
Fastening
Make sure you hear the latch plate engage in
the belt buckle.
Safety belt reminder for front seats
The indicator lamp flashes or lights up.
In addition, a signal sounds. Please
make sure that the safety belts are
being worn correctly.
The safety belt reminder is activated if the
safety belt on the driver's side has not yet been
fastened.
At speeds greater than 5 mph/8 km/h, the
safety belt reminder is also activated if the pas-
senger side safety belt has not yet been fas-
tened, if objects are placed on the passenger's
seat, or if the driver or front passenger's safety
belt is released.
Releasing
1. Hold the belt firmly.
2. Press the red button in the buckle.
3. Guide the belt back into its reel.
The upper shoulder strap's anchorage point will
be in the correct position for seat occupants of
Online Edition for Part no. 01 41 0 014 250 - © 08/07 BMW AG