BMW 650i Convertible 2008 - Manual (Page 47)

Co
n
tr
o
ls
45
Re
fe
re
n
c
e
At
a
g
la
n
c
e
D
riv
in
g ti
ps
C
o
m
m
uni
ca
ti
o
n
s
Na
v
iga
ti
on
En
te
rt
a
in
m
e
n
t
M
o
bi
lity
Do not carry out the next operation,
raising top ends, until the top has
been swung forward, otherwise damage
can occur.
<
4. Raise the two convertible top ends as far as
possible, arrow
5, and close the convertible
top compartment lid, arrow 6.
5. Fold the top ends down onto the convert-
ible top compartment lid.
6. From the interior, take out the cover in the
center of the front top frame; use a screw-
driver if necessary.
7. Insert the Allen wrench into the opening
provided.
8. From the outside, both persons pull the
front frame of the convertible top down-
ward, as simultaneously as possible on the
two sides.
9. Turn the Allen wrench in the direction of the
arrow until the front convertible top frame is
locked to the windshield frame.
The rear convertible top ends are automati-
cally pressed onto the convertible top com-
partment lid and close tightly with tension.
10. If necessary, close the rear window again
manually in the same way as above.
Wind deflector*
The wind deflector keeps the air movement in
the passenger compartment to a minimum
when the convertible top is open, thus enabling
pleasant driving even at higher speeds.
The wind deflector is stowed in a protective
sleeve in the luggage compartment. Short
instructions for use are also provided on the
protective sleeve.
Before installing
1. Remove the wind deflector from the protec-
tive sleeve and fold it open, refer to
arrows
1.
2. Press the upper and lower section together
until the locking device engages, refer to
arrow
2.
3. Push the securing pin 3 out until it engages.
4. Unfold the rear mounts 4.
Online Edition for Part no. 01 41 0 014 242 - © 08/07 BMW AG