BMW 328d xDrive Sports Wagon 2014 - Manual (Page 211)

High beams/headlamp flasher
55-watt bulb, H7.
1. Tilt the bulb down and then up to loosen it
from the holder and remove.
2. Pull the connector off the bulb.
3. Attach the connector to the new bulb.
4. First insert the bulb at the top with the
strap, arrow 1, and then press down firmly,
arrow 2. Make sure that the bulb snaps into
place.
5. Close the headlamp housing with the cap.
Make sure that the cap engages.
Daytime running lights
24-watt bulb, PW24W.
1. If necessary, remove the high beam bulb
connector.
2. Remove the bulb holder.
3. Remove the bulb from the bulb holder.
4. To insert the new bulb, proceed in reverse
order of removal. During insertion, the bot‐
tom of the bulb holder must be facing
downward. Make sure that the bulb holder
snaps into place.
5. Attach the high beam bulb connector.
6. Close the headlamp housing with the cap.
Make sure that the cap engages.
Xenon headlamps
Xenon headlamps
Because of the long life of these bulbs, the
likelihood of failure is very low. Switching the
lamps on and off frequently shortens their life.
If a bulb fails, switch on the front fog lamps and
continue the trip with great care. Comply with
local regulations.
Do not perform work/bulb replacement
on xenon headlamps
Have any work on the xenon lighting system,
including bulb replacement, performed only by
a service center. Due to the high voltage
present in the system, there is the danger of
fatal injuries if work is carried out improperly.◀
For checking and adjusting headlamp aim,
please contact your BMW center.
Seite 211
Replacing components Mobility
211
Online Edition for Part no. 01 40 2 925 793 - II/14