FASS FA C09 220G - Manual (Page 10)

E. Remove filler neck tube and over-flow tube from the top of the
fuel tank by loosening clamp. Some models have an integrated
filler neck. If your over-flow is integrated, be careful not to hang
up the internal flow tube when lowering the tank.
B. If necessary, carefully bend the sheet metal down that is cov-
ering the side.
Some of the photo’s are of a different application, procedures are the same.
D. Using a fuel line disconnect tool, disconnect the factory suction line located above the fuel cooler.
Place the disconnect tool around the fuel tube and slide the tool under the fuel line connection to re-
lease the fuel line. Pinch in tabs on 2011- models.
2011-Present
C. This step can be omitted on 2011– models. Remove the 3 bolts holding the fuel cooler to the mount-
ing bracket. The fuel cooler is located in front of the fuel tank.
A. Very Important: Before removing the fuel tank, identify “ALL”
areas of clearance between the tank and bed to install the draw tube
assembly. The closer the suction tube is placed to the center of the
fuel tank, front to back and left to right, the more usable fuel there
will be!