FASS T 200G - Manual (Page 18)

L. In the same manner as previously covered, route and loosely connect the assembled fuel lines discussed
in this section to the appropriate points of connection including the ‘T’.
G. Cut the fuel line and assemble a –8 AN hydraulic fitting in the opposite end of
the line connecting to the “R” port of the FASS.
F. Attach the line completed in Step 4b to the return port of the FASS labeled with
an “R”. Route to the center of the nearest cross member aligned with the ports in
the fuel tank being used for return fuel. Measure & mark this line as it will con-
nect to the 90° fitting of the “T” in this location.
M. Torque all connections to 18 ft./lbs. Secure the fuel line and all fittings. Continue to Step 5
H. Assemble a –8 AN hydraulic fitting into one end of the remaining fuel line.
Route this fuel line from straight fitting of the “T” to the return port in the fuel
tank, mark & cut.
I. Caution: Route the side with the exhaust first as it may be necessary to travel below the frame to
avoid the exhaust, each side has to be the exact same length. Later it will install as seen.
J. Cut the remaining fuel line to the “Exact” same length line as the line in Step 4f.
K. Assemble (2) of each -8 AN Straight into each side of the line addressed in Steps 4f & 4g.