FASS T C10 150G User Manual
Page 16
E.
Reattach the 3 bolts holding the fuel cooler to the mounting bracket.
B.
Measure from the factory feed connection from Step 2d to the ‘E’ port of the FASS system. Cut and
insert PL-1005. Connect to the 10-300 in the ‘E’ port of the FASS system. Torque to 18 ft./lbs.
C.
Using oil, insert a PL-1005 into the remaining fuel line. Connect to the ‘R’ port fitting on the FASS
system. Torque to 18 ft./lbs. Route this line in a gentle bend to the Return Manifold. Slide over return
tube and secure with HC-1001 clamp.
Do Not use sealant on AN (male flare) fittings. Only use sealant on threads installed into pump assembly.
A.
Route suction line from the factory module to the ‘T’ port of the
FASS pump. Cut FL-1002 to length. (measure twice cut once) In-
sert PL-1005 using oil. Attach to 10-301. Torque to 18 ft./lbs.
Note: Secure all fuel lines with cable ties. Cable ties are an economical way to prevent the
possibility of problems occurring!