Crestron electronic Network Distribution Block - Manual (Page 6)

Multi-Type Network Distribution Block Crestron CNHBLOCK
4
••
Multi-Type Network Distribution Block: CNHBLOCK Operation & Installation Guide - DOC. 8157
CNHBLOCK With Mounting Plate
C NHBLO CK ALL CONNECTORS ARE IN PARALLEL
4
D A
1
B C
Y
Z
G
24
2
Y
Z
G
24
3
E
a
POWER
5
Y
Z
G
24
6
b c
Y Z
8
Y
Z
G
24
7
CRESTRON CRESTRON
24
Y
Z
G
24
Y
Z
G
24
Y
Z
G
Rack Installation
The CNHBLOCK may also be installed into a rack by using a CNXRMAK (not supplied).
Perform the following steps to install the CNHBLOCK into a rack. The only tool required for
this procedure is a #2 Phillips screwdriver.
1. Using a #2 Phillips screwdriver, remove the four mounting screws (shown
below) that secure the mounting plate to the CNHBLOCK and remove the plate.
Detach Mounting Plate
2. For further instructions, refer to the latest revision of the CNXRMAK Installation
Guide (Doc. 8156). This document can be obtained from the Downloads page
(MANUAL Library) of Crestron’s website (www.crestron.com). Search for
CNXRMAK.PDF. New users are required to register in order to obtain access to
the FTP site