Dogtra YS200 - Manual (Page 6)

8
CONTACT POINTS
NOTICE :
When first using the “Yapper Stopper”, it is
recommended that you start with the lowest level.
If the dog continues to bark, gradually increase the
intensity level.
A long set of contact points is included.
The contact points must make good contact with the
skin for the unit to function properly.
IMPORTANT : When screwing in the contact points,
tighten by hand only.
9
Periodically wash the “Yapper Stopper” with alcohol
or detergent. Before washing, make sure that the
battery cap is tightened.
Dry thoroughly after washing.
MAINTENANCE
Tighten the collar around the dog’s neck so that the
points are in contact with the dog’s skin.
If the collar is too loose, the dog will not receive
correction when it barks.
Check the dog’s neck daily for possible irritation
caused by the contact points rubbing the skin.
Do not leave the collar on for more than eight hours a
day.
FITTING THE COLLAR
IMPORTANT : Remove any other collars from your
dog when it is wearing the Yapper Stopper.
A metal collar or metal buckle that rubs against the
Yapper Stopper bark sensor may inadvertently activate
the unit.