beautypg.com

Dogtra iQ No Bark Collar User Manual

Page 5

background image

- 4 -

* The iQ No Bark Collar has a preset delay of 15 seconds in-between
corrections. Once the unit activates, it WILL NOT activate again until
15 seconds has gone by. (The unit will reset to the warning
non-stimulating vibration after 17 seconds of a correction if the dog
does not bark.)

- Turn the On/Off and Intensity Dial to (T), for the test mode. The LED
indicator will flash once, and after 2 seconds it will continue flashing
every 2 seconds.
- Activate the collar by making sounds directly into the mic. The unit
should now vibrate twice. After waiting 15 seconds, repeat the test once
more to verify that it is fully functional.

1. With the On/Off

Intensity Dial going in

first, insert the body of

the iQ No Bark Collar

into the collar strap.

3. Be sure that the collar

strap is wrapped fully

around the body of the

iQ No Bark Collar.

2. Pull the collar strap

from the opposite side

of the On/Off Intensity

Dial over the rest of

the body.

Hold strap here

Hold strap here

Pull the strap around the body

of the iQ No Bark Collar

in the direction shown.

ATTACHING THE COLLAR STRAP

TESTING THE IQ NO BARK COLLAR

- When the iQ No Bark collar is first activated by the dog’s bark, the
unit will give a warning non-stimulating vibration. If the dog
continues to bark, the unit will give a non-stimulating vibration
followed by a correction at the level it is set on.

* When on the test mode, the sensor may be sensitive enough that it may
activate easily by a quiet sound or tap.

* For video instructions on how to attach the collar strap, please visit
ZZZLTSHWFROODUFRP