Charging the receiver/collar – Dogtra eF-3000 Gold User Manual

Page 9

CHARGING THE RECEIVER/COLLAR

uses Lithium-Polymer batteries.

1. Charge the unit before using the unit for the first time.
2. Do not charge the batteries near any flammable substances.
3. Fully charge the batteries if the unit is to be stored without use for a

period of 3 months or more.

Recharge the unit if :

- The LED indicator light on the collar receiver is emitting a red color.
- The indicator light on the receiver will not come on.
- The indicator light on the receiver comes on momentarily, but will not

stay on near the wire.

Battery Charging Procedure

Note : The unit has a partial charge when it leaves the Dogtra facility, upon

receipt of the collar, be sure to give it a full 2-hour initial charge
before the first use.

1. Attach the charging cables to the receiver as shown.

2. Plug the charger into a 120-volt wall outlet.

When properly plugged in, all indicator lights should glow red.
During the charging process, the unit will shut off. Once the battery
cable is unplugged from the unit after a full charge, you will need to turn

CHARGING THE RECEIVER/COLLAR

the unit on again before use.

3. The Lithium-Polymer battery is fully charged within 2 hours. The

lights will stay red during the charging process. The red light will
change into a steady green light when the battery is fully charged.
(When you disconnect the charger after finishing the charge, you will
need to restart the units).

4. After charging, cover the battery charging receptacles with the rubber

plugs on the transmitter and receiver.

NOTE : Only use Dogtra-approved batteries,
chargers, and accessories for the
When a charger is not in use, disconnect it from the power source.